ページを印刷する
DRX Active Series
Model
System
Continuous power
Total harmonic distortion
S/N Ratio
Line input Level
Input Impedance
Indicator
Power supply
External controls
SPL@1m
Frequency Response
Woofer
Driver
Horn Coverage (H*V)
Enclosure Construction
Mounting
Dimensions (H x W x D)
Troubleshooting
This troubleshooting guide is meant to help solve simple problems. If a problem occurs, carry out the steps
below in sequence until a solution is found. Once the unit operates properly, do not carry out following
steps.
1.
If the device does not operate properly, unplug the device.
2.
Check the fuse, power from the wall, all cables, etc.
3.
If all of the above appears to be O.K., plug the unit in again.
4.
If you are unable to determine the cause of the problem, do not open the device, as this may
damage the unit and the warranty will become void.
5.
Return the device to your Dap Audio dealer.
DRX-15A
2-Way Active Vented Speaker Cabinet
LOW: 220W / HIGH:30 W
LOW-input/-3dBu 100Hz, out load 4 Ohms , THD＜0.5%
HI-input/-3dBu 15KHz, out load 8Ohms, THD＜0.5%
LOW:＞80dBu / HI:＞70dBu
-5dBu ± 1dBu
Line 15KΩ input
Power ,Clip,Signal
115 V 60 Hz / 230 V 50 Hz Switchable
Volume Control / Power ON with Green LED / Clip Limiter
with Red LED/Ground Lift.
96.5 dB / 123.5 dB (Max.)
50Hz - 20kHz - 6dB
15" Ø 381mm - 2" Voice Coil
1" Driver - 1" Voice Coil
50° x 50°
15mm plywood cabinet, glued and reinforced, resistant
black paint; metal grille, rubber foot.
One ABS plastic standard pole-mount
522 x 486 x 736mm
17