ページを印刷する
Example 3: using the 8Ω output with two 4Ω speakers.
Fig. 5
In a low impedance system, the total speakerload should always match the amplifier
impedance This to avoid overloading the amplifier. The total speaker power should be at least
the power of the amplifier to avoid damage to the speakers.
High impedance outputs
If using either the 70V outputs or the 100V outputs, note that all speakers should be wired in parallel.
The total power of all speakers summed together should never exceed the total power of the
amplifier in a high impedance (70V or 100V) system!
Connection Cables
Take care of your cables, always holding them by the connectors and avoiding knots and twists when
coiling them: This gives the advantage of increasing their life and reliability.
Periodically check your cables. A great number of problems (faulty contacts, ground hum, discharges,
etc.) are caused entirely by using unsuitable or faulty cables.
Headphones
Unbalanced mono
Balanced mono
Insert
10