- ページ 7

アンプ DAPAudio D6162のPDF マニュアルをオンラインで閲覧またはダウンロードできます。DAPAudio D6162 12 ページ。 Public address amplifier

PA-16120 Public Address Amplifier

Backside

HPF switch

Move the switch to toggle between FLAT and the 180Hz high pass filter for each input signal.

Mode selection switch

Set the amplifier to one of the 3 modes: parallel (PA), 2-channel mode (2CH), bridge (BR).

IEC power connector 100-240V AC + Fuse T10AL/250V

Connect the device to the appropriate power supply.

Terminals - amplifier OUT

These terminals provide 100V voltage per output, for commercial and industrial use.

Cooling fan

Volume controls (channels 1-16)

Turn these controls to adjust the output level.

Terminals – signal IN (dual signal per terminal)

Connect an input signal source.

Remove all packing materials from the PA-16120. Check if all foam and plastic padding is removed.

Secure the equipment into a 19" rack if preferred. Connect all cables.

Always disconnect from electric mains power supply before cleaning or servicing.

Damages caused by non-observance are not subject to warranty.

Before plugging the unit in, always make sure that the power supply matches the product specification

voltage. Do not attempt to operate a 110V specification product on 230V power, or vice versa.

Damage caused by connecting the amplifier to improper AC voltage is not covered

by any warranty!

Always turn off and disconnect the amplifier from mains voltage before making audio

connections. The attenuators should always be turned down during power-up.

Ordercode: D6162

Fig. 02