- ページ 8

アンプ DAPAudio Falcon 1500のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。DAPAudio Falcon 1500 17 ページ。 Dap audio falcon stage amp series

Frontpanel

1. Thermal LEDs

Indicates that the channel is in Thermal protect mode.

2. Fault LEDs

Indicates that the unit is in protection mode due to a fault condition. The fault can be caused by over

temperature of the heatsink or DC voltage on the output. While in protection mode, the speakers are

disconnected from the amplifier by an internal relay. While powering on, the fault LED will light for

approximately 3 seconds. The fault LED will dim if the start up cycle is completed or the problem is

solved.

3. Rack Mounting Holes

Two front panel mounting holes are provided on each mounting flange,

4. Fan Inlet Grills

Falcon series amplifiers are cooled by two, rear-mounted fans, Cool air flows over the heat sinks and

exhausts through the rear grills, Make sure these outlets remain clear to allow unrestricted air flow,

5. Level Indicator

6. Power LEDs

Indicates that the channel is active.

7. Clip LEDs

If the output signal distortion exceeds 1%, the Clip LED will light up in orange. Decrease the input level

by the Input attenuators (8) counterclockwise.

8. Input Attenuators

Whenever possible, set attenuators fully clockwise to maintain optimum system headroom. The input

attenuator controls (one for channel A, one for channel B) located at the front panel adjust gain for

their respective amplifier channels in all modes. See the specifications at the end of this manual for

standard voltage gain and input sensitivity information.

9. AC Power Switch

This is the main Power switch. Press to turn the amplifier on.

Fig. 2