ページを印刷する
Qi-4200 / 4400 / 4600
Backside
IEC power connector 120-230V + internal fuse
Speakon speaker output connectors
Channel 3 / Channel 4 stereo / mono / bridge switch
Channel 1 / Channel 2 stereo / mono / bridge switch
Channel 3 / Channel 4 mode switch
3-pin XLR balanced inputs
Channel 1 / Channel 2 mode switch
Installation
Remove all packing materials from the Qi. Check if all foam and plastic padding is removed.
Fit the equipment to a 19" rack. Connect all cables.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 240V power, or vice versa.
Install this device on a flat surface, not bending or curved.
Do not supply power before all components of the system are set up and connected properly.
Ordercode: D4530 / D4531 / D4532
6
Fig. 02