- ページ 10

音楽ミキサー DAPAudio IMIX-7.1のPDF マニュアルをオンラインで閲覧またはダウンロードできます。DAPAudio IMIX-7.1 16 ページ。 7 channel 2u install mixer

IMIX 7.1

21. Aux mini jack in connector

Unbalanced stereo mini jack aux input for connecting a line/phones level device. Use the phone/line

(23) switch to set up this input for connecting either headphone or line level output devices.

22. Aux RCA in connectors

Unbalanced stereo RCA aux input for connecting a line/phones level device. Use the phone/line (23)

button to set up this input for connecting either headphone or line level output devices.

23. Phone/line button

Use this button to configure both aux (21,22) inputs for either line level or phone level.

When the input level is too low, press the line/phone level switch. When the light is on, the level of the

input signal will be boosted. The phone level adjusts the input sensitivity into the correct level for MP3

players, smartphones or tablets. Now you can playback your MP3 devices directly without signal loss.

24/25/26. Equalizer section (master 1, 2, 3)

The master equalizer section allows shaping of the outgoing audio signal. All master channels are fitted

with 3-band EQ. The high (26) and low (24) shelving controls have their frequencies fixed at 12KHz and

80Hz respectively. The mid (25) range control has a peaking response frequency at 1KHz. All 3 bands

have up to 12dB cut and boost, with a centre detent for off. Turning the Equalizer to the right amplifies

the frequency range, turning to the left attenuates the signal. Minor changes to the Equalizer control

usually produce the best results. Try to avoid excessive enhancement of the mid band.

27. Headphones level control

This control allows you to adjust the headphones' volume.

28. Line level control

This control allows you adjust the level of the aux (21,22) inputs in the master mix.

29. Headphone out connector

You can connect a pair of headphones with an impedance of 32 - 600 Ohm to the headphones

connector. It is a 6,3mm/ 1/4" TRS socket, wired as Tip=left, Ring=right and sleeve = ground.

Caution: Depending on the type of headphones connected to the Headphones jack, the IMIX-7.1 is

capable of producing high output levels via the phones output. Therefore, make sure to turn the

control all the way to the left (minimum setting) before connecting the headphones. Be aware of the

fact that listening to loud sound pressure levels over a longer period of time leads to hearing damage!

Ordercode: D2350

18. Master control (master 1- 3)

You can adjust the output signal to the Master

Outputs (42, 43, 44, 45, 46, 47) outputs.

19. Output Signal VU Meter (master 1, 2)

This meter is a multi-step LED. The accurate

level indication allows you to monitor the

output signal level at any time, and match

with other devices.

20. Ratio control

Use this control to make a headphone mix

between your PFL and your master signal.