- ページ 7
リモコン Duratech LINK Touch DLT10-RGBのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Duratech LINK Touch DLT10-RGB 14 ページ。
ページを印刷する
Connecting to ...
SETTINGS
Pair
start
Pairing
This "Pairing"-mode will allow the LinkTouch
connection with other devices such as :
- Link Controllers, Link Master, linking per functionality
lights, cover)
- The heat pump
Note : In case the Link Master is already linked with cover and lights and
heat pump, it will distribute the links to the LinkTouch
Make sure the LinkTouch
TM
is in close proximity (<2m) of the device which
you would like to pair with wirelessly. Select "Pair Start" on the LinkTouch
Power on the device.
The device will be in pairing mode for about 2 minutes after switched on.
The LinkTouch
TM
will now be pairing with the device.
12
Select "Pair Start"-mode from the
settings menu.
Touch the screen once to put the
LinkTouch
in pairing mode.
TM
TM
to establish a wireless
TM
automatically.
TM
Cover operation settings
There are 2 modes:
Deadman switch operation enabled:
The cover operation will run when pressing and holding the finger
on the button and will stop when releasing the finger from the button.
Deadman switch operation disabled:
The cover operation will run with a single touch of the button
and will stop when touching the button again.
SETTINGS
Aux setting
cover
SETTINGS
Aux setting
cover
SETTINGS
DeadManSwitch
enabled
.
Warning :
For safety reasons :
1. The cover can only be operated when the remote device is connected to the wall mount in
case the "Deadman switch" operation mode is enabled.
2. The wall mount should be installed in close proximity of the pool to make sure that when
operating the cover with the remote device, the pool is always in sight of the operator.
Note that the wall mount can only be mounted indoor. Do not mount outdoors.
3. The operator must ensure that the path for the cover is clear and nobody gets in-
jured,
while
operating
held responsible for any damage or injury during the operation of the cover.
Note that Propulsion systems cannot be held responsible for any damage or injury during the
operation of the cover.
Go to "AUX SETTING" in the settings
menu.
Touch the screen and select "COVER".
Go to "DEADMANSWITCH" in the
settings. Touch the screen to select
"DEADMANSWITCH ENABLED".
the
cover.Note
that
Propulsion
systems
cannot
be
13