ページを印刷するWHAT'S INCLUDED
•
Heat Gun.
•
Instruction manual.
OPERATION
•
Always observe the safety instructions and applicable regulations.
•
Use only one hand to hold the tool, do not place your other hand over the air vents
Prior to operation :
•
Mount the correct accessory for the application.
•
Set the desired pre-set air temperature (see table below).
Setting
Application
Drying paint, varnish, filler, adhesives, construction joints and stucco
forms.
Drying wet timber.
I
Removing stickers.
Fixed
Joining adhesives:- Large-surface gluing with contact adhesives,
heat at
activation of pressure sensitive adhesives, acceleration of bonding
o
50
C with
processes, releasing or bonding of edge band or veneer.
variable
fan speed
Waxing and de-waxing.
Shrinking PVC wrapping and insulation tubes.
Defrosting of frozen items.
Welding of thermoplastic polymer, flooring materials of PVC and
I I
linoleum, PVC-coated fabric, tarpaulins and foils.
Variable
Bending plastic pipes and sheets.
temp from
50
o
C to
Soldering plumbing joints.
650
o
C
Loosening rusted or tightly fastened nuts and bolts.
with
variable
Removing old and even thick coatings of oil paint, lacquer, varnish and
fan speed
synthetic plaster.
•
For greater control press any of the adjusting
buttons.
•
In setting II press buttons 1 or 2 to increase
or decrease the outlet air temperature.
•
In either setting press buttons 3 or 4 to
increase or decrease the air flow and on
the LCD an indicator starts to flash. When
the temperature adjustment is complete the
flashing ceases.
•
The LCD will display the temperature in digits
and air flow as a graph.
•
The temperature displayed will increase or
decrease by 10
o
C increments.
1
3
2
4