- ページ 5

ペイントスプレー DAPC DAPCのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。DAPC DAPC 11 ページ。 Multi-purpose spray gun

TO USE PRESSURE FEED

Mix material according the manufacturer's instructions. Mixture should be

smooth and easily pourable. Lumps or foreign particles should be removed by

straining through a suitable paint filter.

Fill the material cup (a) 3/4 full.

Attach material cup (a ) to the gun

securely.

Attach air supply line to 1/4 NPT air inlet

(c).

Adjust spray pattern.

The position of the air cap horns (g) will de-

termine the spray pattern. Loosen air cap (h)

and rotate horns to achieve desired pattern.

Tighten air cap.

Turn fluid control knob (b) clockwise until it

stops, do not force. This will shut off the fluid

flow. NOTE: The fluid or density of "fan spray" is controlled by fluid control

knob (b).

Adjust air pressure to 40 psi at air compressor.

NOTE: Care should be exercised when handling spray gun to avoid damage to the

orifice of the air cap and tip of fluid nozzle. Damage to these parts results in irregular

spray patterns.

Depress spray gun trigger (d) and gradually turn the fluid control knob (b)

counterclockwise until desired fluid flow is reached. Trigger gun quickly, one

second on-off to test pattern.

NOTE: If gun sprays too fast, decrease the fluid pressure. If too slow, increase the

pressure. Turn fluid control knob (b) counterclockwise to increase, or clockwise to

decrease, the fluid flow.

If spraying heavy duty, slow drying material replace external air cap with internal

air cap.

To replace:

Remove air cap retainer (h).

Remove external air cap and replace with internal air cap (supplied).

Replace air cap retainer (h).

DO NOT exceed 50 psi.

NEVER point spray gun at self or any other person. Acci-

dental discharge of material may result in serious injury.

5- ENG

Horizontal position

Vertical position

D27122