- ページ 10

屋外倉庫 Duratuf SENTRY SHEDS SS1515のPDF 組立説明書をオンラインで閲覧またはダウンロードできます。Duratuf SENTRY SHEDS SS1515 15 ページ。

ページを印刷する

ASSEMBLE FRONT PANEL

SELECT:

1 x 1.890 Wall Sheet

1 x 1.520 Top Plate (Red)

1 x 1.520 Bottom Plate (Green)

1 x 1.890 Door Jamb Flashing

1 x 1.890 Corner Door Jamb Flashing

16 x 30mm Galv Clouts

13 x Rivets

STEP 1:

 Lay out 1 x Top Plate and 1 x Bottom Plate on a flat

surface as shown

NOTE:

The Doorway is standard at the left-hand end but can

be put on the right-hand end.

STEP 2:

 Using 2 x 30mm clouts, nail the Door Jamb Flashing flush with

the top of the Top Plate at the correct measurement as shown

in plan view. Pre drill holes using a 3.5mm drill bit

 Check the distance between the top and bottom plates then use

a further 2 x 30mm clouts to nail the Door Jamb Flashings to

the bottom Plate. Pre drill holes.

STEP 3:

 Place 1 x Wall Sheet on timber plates and rivet the sheets

together as shown.

 Ensure that the top of the sheet is flush with the top of the

Top Plate and that the sides of the wall sheet overhang the

Top Plate by 15mm as shown. Nail wall sheets to Top Plate

(two clouts per pan)

 Nail the wall sheets to the Bottom Plate making sure that the

Plates are the correct distance apart and that the sides of the

wall sheets overhang the Bottom Plate by 15mm.

 Drill & rivet Door Jamb Flashings to wall sheets using four

rivets equally spaced on each side.

NOTE:

Door can be hinged on either side.

STEP 4:

 Place the door on the panel (In open position, approx 5mm

below top plate). Using two rivets, rivet the top and bottom

hinges to the Door Jamb Flashing.

 Ensure the door closes properly, then fit remaining rivets.

IMPORTANT—IF YOU CHOOSE TO RAISE YOUR TIMBER

BASE PLATE –READ THE FOLLOWING;

For sheds with Raised Base Plate option only (see page 5), deduct

30mm from measurement shown between Top and Bottom Plates on

all wall panels, so cladding protrudes 20mm below bottom plate

1834mm

15mm

TOP PLATE

BOTTOM PLATE

Plan View

TOP PLATE

DOOR OPENING

960mm

530mm

NAIL

1834mm

TOP

PLATE

DOOR

JAMB

15mm