- ページ 9

ワークライト DARAY X350のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。DARAY X350 20 ページ。 Led examination light

3. Operation

Position the light by moving it using the handle provided on the main stand.

Note: The light must not be lifted using the light-head handle or gooseneck. To position the

light, hold the upstand and move the light-head using the handle.

The front castors on the base have brakes which can be used to help keep the base from moving

whilst the light-head position is adjusted.

Unwrap the flex from the cable holders and plug the IEC connector into the base ensuring the

metal safety retainer is fitted over the top of the IEC plug connector.

Once connected to the mains, switch the illuminated power switch ON and the green indicator

will be illuminated. If the indicator does not illuminate, check the power supply and then check

the fuses located in the IEC socket on the mobile base (see section 5. FUSE REPLACEMENT) and

also in the mains plug. Further fault investigation should only be carried out by a qualified

electrician.

3.1 Turning the light ON/OFF and adjusting the

intensity

There is a rocker switch on the light-head near the handle. This is a

momentary type switch and does not latch.

 Press the switch once to turn the light ON

 Press and hold to decrease intensity

 Press and hold to increase intensity

 Press the switch once again to turn the light OFF

Note: If mains power is removed by either unplugging or

turning off at the base, the intensity will be reset to its

brightest setting when the light is powered on again.

The light-head can be rotated on the flexible arm which itself can

be bent almost double so the light patch may be directed at will.

Illuminated

power switch

IEC mains

connector

Rocker

switch

Light-head

handle

Page 8 of 17

Safety

retainer