- ページ 16

換気 DuraVent DAS1のPDF マニュアルをオンラインで閲覧またはダウンロードできます。DuraVent DAS1 20 ページ。 Ul 1978 - grease duct professional series kitchen ventilation

ECCENTRIC TAPERED INCREASER (ETIN)

Used when a pipe diameter change and a flat bottom on

horizontal runs is required.

Figure 41: Eccentric Tapered Increaser

ROUND FLANGED HOOD ADAPTER (RFHA)

Used to connect the first duct section to the hood. Can be field

welded or supplied to the HOOD manufacturer for installation

(by others)

Figure 42: Round Flanged Hood Adapter

SQUARE TO ROUND ADAPTER – CUSTOM PART

Used to connect a round duct to a hood with a

square/rectangular collar or to connect to a square duct.

STR's are a custom component and all requests need to go

through the DuraVent Design Group at [email protected].

Figure 43: Square to Round Adapter

ECCENTRIC SQUARE TO ROUND ADAPTER – CUSTOM

PART

Used to connect a round duct to a hood with a

square/rectangular collar or to connect to a square duct.

ESTR's are a custom component and all requests need to go

through the DuraVent Design Group at [email protected].

Figure 44: Eccentric Square to Round Adapter

CIXPRO SERIES FOR GREASE DUCT UL1978 SUBMITTAL RECORD

SECTION F – SUPPORTS

Refer to Table 5 for MAXIMUM HEIGHT / SPACING

HALF ANGLE RING (HAR)

Used for supporting and guiding the duct in horizontal runs.

Hardware by others.

Figure 45: Half Angle Ring

FULL ANGLE RING (FAR)

Used for guiding on a vertical run and allows movement for

thermal expansion.

Figure 46: Full Angle Ring

LENGTH ANCHOR PLATEE (APL)

Used for supporting the duct in vertical or horizontal runs and

to provide a fixed point for thermal expansion consideration.

Must not be in contact with combustible material.

Figure 47: Length Anchor Plate

ANCHOR PLATEE (AP)

Used for supporting the duct in vertical or horizontal runs and

to provide a fixed point for thermal expansion consideration.

Must not be in contact with combustible material.

Figure 48: Anchor Plate

REV: 0

AUGUST 2017