- ページ 3
スイッチ Contemporary Control Systems EISK8-100T/FTのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Contemporary Control Systems EISK8-100T/FT 4 ページ。 Plug and play fibre switching hub for industrial automation systems
ページを印刷するPower Options
Power Considerations
Voltage in the range of 10–36 VDC or 8–24 VAC must deliver current commensurate
with power consumption. Recommended size for solid power conductors is 16–22 AWG;
for stranded conductors, use 16–18 AWG. Common is directly connected to zero volts
and chassis is isolated from zero volts. Input connections are reverse-polarity protected.
LED Indicators
The "PWR" LED glows solid green when the switch is properly powered. To aid in
troubleshooting, each copper port has two LEDs. The Port 1 LED labelled "L" glows
solid if a link exists, flashes to show activity and shows data rate by colour: green for
100 Mbps and yellow for 10 Mbps. The LED labelled "D" glows solid green if full-duplex
is on or is unlit when the port is in half-duplex mode — but in half-duplex operation it
will flash if a collision occurs. The LEDs of Ports 2–6 are unlabeled but work the same.
The fibre port (7 and 8) LEDs glow solid green if linked to a working 100BASE-FX port
and each LED flashes when data moves through the port.
Network Connections
The switch employs Auto-MDIX
technology
so
straight-through or crossover
cables can be used to connect to
network interface adapters or to
other hubs. Cable issues are
shown in the chart to the right
that
either
Signaling &
Medium
Data Rate
Copper
10BASE-T
100BASE-TX
10/100 Mbps
Fibre
100BASE-FX
100 Mbps
Mini
mum
Maximum
Cabl
e
Segment
Needed
Distance
CAT 5 UTP
100 m (328 ft)
Multimode
Full-Duplex :
50/125 or
2 km (6562 ft)
62.5/125 µm
Single Mode
Full-Duplex :
15 km (49212 ft)