- ページ 14

コントローラー Contemporary Research ICC1-IRXのPDF 製品マニュアルをオンラインで閲覧またはダウンロードできます。Contemporary Research ICC1-IRX 19 ページ。 Ir tv controller, 1-way rf coax control

ページを印刷する
Contemporary Research ICC1-IRX 製品マニュアル

RS-232 Commands

Command
Power
Power Off
Power On
Power Toggle
Volume
IR Type
Channel Entry
Contemporary Research
Description
This series of commands uses the sensed power capability of the ICC1-IRX.
P0
"$A5,<dh>,<dl>,2,'P0' " (6 bytes)
P1
"$A5,<dh>,<dl>,2,'P1' " (6 bytes)
PT
"$A5,<dh>,<dl>,2,'PT' " (6 bytes)
VL
"$A5,<dh>,<dl>,3,'VL',<vol level>" (7 bytes)
Sets TV volume level
0 = Mute
1 – 63 = Minimum level (1) to maximum volume (63)
T1
"$A5,<dh>,<dl>,3,'T1',<type> " (7 bytes) – Sets IR device type
Identical to using DIP switch to set IR control codes. Specify value to match IR code type.
Add 64 to the IR code to set the ICC1-IRX to ignore the power sensor – if the type is
specified as Sensor – discrete types always ignore the sensor input.
T3
"$A5,<dh>,<dl>,3,'T3', <format>" (7 bytes) – Modifies entry format for channels
Zero (0) value uses format defined by IR Type.
Add the total value for the formats below:
128 = Add Enter after channel number (105 + Enter)
64 = Add +100 to channel number (105 = +100, 05 – use 3 digit tuning)
3 = 3 digits (Ex: 007, 032, 105 – ICC1-IRX inserts leading zeros, if needed)
2 = 2 digits (Ex: 07, 32 – ICC1-IRX inserts leading zero, if needed)
1 = 1 digit (Ex: 7)
Ex: "$A5,<dh>,<dl>,3,'T3', 131" Adds Enter, uses 3 digits for channel entry
Tips on using Channel Entry:
The IR Type setting includes a channel entry format normally used by the displays in that
control group. However, sometimes a manufacturer changes the entry format for some
models. Using the Channel Entry command, you can adapt to a different entry format
without changing your system programming. For example, in the +100 Channel Entry mode,
the ICC1-IRX will receive a command for Channel 122 and translate that to a +100
command, followed by 22.
Note that the IR Type command sets a pre-defined Channel Entry format. If you change or
re-send an IR Type command to the ICC1-IRX (or change with DIP switches), you'll need to
send a Channel Entry again to add the modifications.
14
ICC1-IRX