- ページ 11

ネットワーク・ルーター Contemporary Research ICC1-IRのPDF 製品マニュアルをオンラインで閲覧またはダウンロードできます。Contemporary Research ICC1-IR 17 ページ。 Ir tv controller, 1-way rf coax control
Contemporary Research ICC1-IR にも： 仕様 (2 ページ)

ページを印刷する
Contemporary Research ICC1-IR 製品マニュアル

RS-232 Commands

Command
Power
Power Off
P0
Power On
P1
Power Toggle
PT
Volume
VL
IR Type
T1
Channel Entry
T3
Contemporary Research
Description
This series of commands uses the sensed power capability of the ICC1-IR.
"$A5,<dh>,<dl>,2,'P0' " (6 bytes)
"$A5,<dh>,<dl>,2,'P1' " (6 bytes)
"$A5,<dh>,<dl>,2,'PT' " (6 bytes)
"$A5,<dh>,<dl>,3,'VL',<vol level>" (7 bytes)
Sets TV volume level
0 = Mute
1 – 63 = Minimum level (1) to maximum volume (63)
"$A5,<dh>,<dl>,3,'T1',<type> " (7 bytes) – Sets IR device type
Identical to using DIP switch to set IR control codes. Specify value to match IR
code type.
Add 64 to the IR code to set the ICC1-IR to ignore the power sensor – if the type is
specified as Sensor – discrete types always ignore the sensor input.
"$A5,<dh>,<dl>,3,'T3', <format>" (7 bytes) – Modifies entry format for channels
Zero (0) value uses format defined by IR Type.
Add the total value for the formats below:
128 = Add Enter after channel number (105 + Enter)
64 = Add +100 to channel number (105 = +100, 05 – use 3 digit tuning)
3 = 3 digits (Ex: 007, 032, 105 – ICC1-IR inserts leading zeros, if needed)
2 = 2 digits (Ex: 07, 32 – ICC1-IR inserts leading zero, if needed)
1 = 1 digit (Ex: 7)
Ex: "$A5,<dh>,<dl>,3,'T3', 131" Adds Enter, uses 3 digits for channel entry
Tips on using Channel Entry:
The IR Type setting includes a channel entry format normally used by the displays
in that control group. However, sometimes a manufacturer changes the entry
format for some models. Using the Channel Entry command, you can adapt to a
different entry format without changing your system programming. For example, in
the +100 Channel Entry mode, the ICC1-IR will receive a command for Channel 122
and translate that to a +100 command, followed by 22.
Note that the IR Type command sets a pre-defined Channel Entry format. If you
change or re-send an IR Type command to the ICC1-IR (or change with DIP
switches), you'll need to send a Channel Entry again to add the modifications.
11
ICC1-IR IR TV Controller