- ページ 4

計測機器 493K K-METRONのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。493K K-METRON 18 ページ。 Thickness measurement gauge with radio link up and software recording

1 OPERATING THE K-METRON

1.1 Turning the unit ON & OFF

To turn the unit ON momentarily press the ON/OFF switch on the face of the K-METRON

until the left-hand POWER LED illuminates. Battery level will be checked each time the unit

is turned on, and if a low battery voltage is detected then a warning will be displayed on

start up.

To turn the unit OFF press the ON/OFF switch on the face of the K-METRON unit the POWER

LED goes off.

Visual Display

Power LED

Delete Last

Transmitted

Data

The unit will auto power off after 3 minutes of inactivity. A warning "PWR OFF" is displayed

after 1 minute of inactivity. The unit can be interrupted from auto power off by pressing

either the orange trigger or the DELETE button; pressing either will only interrupt the auto

power off and will neither 'transmit' or 'delete' any data.

1.2 Entering the Configuration Menu

To enter the configuration menu, with the K-METRON turned off, hold down the DELETE

button and switch the unit on. While continuing to hold down the DELETE button, the

display will read "Wait ... Setup mode". Once the display reads "M1: Cal Object" release the

DELETE button. The unit is now in the Configuration Menu. To scroll through each menu use

the DELETE button; to select use the Orange Trigger Button.

Place the Sensor Head on one face of the product that is to be measured. Hold or place the

magnet on the opposite side of the product wall until it couples to the sensor head.

3 |

P a g e

K-METRON Radio User Instructions (Firmware 2.3.4; Doc v3.0.0)

Sensor Head Dock

Sensor Head

ON/OFF

Switch