- ページ 15

モニター Aplex ADP-1120のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Aplex ADP-1120 16 ページ。

2.4 AD Board (TB-6020) OSD Functions

1.) Getting into Burn-in Mode

Before setting into a burn-in mode, first disconnect the AC power cord. Then press (don't let them go)

the

buttons until the AC power cord is connected and the "RGB" appears on the top left corner

of your screen. Now it can be put into the burn-in mode for changing colors.

2.) Getting Out of Burn-in Mode

Before getting out of the burn-in mode, please first disconnect the AC power cord. Then press the

button (If not workable, press the

connected. Please don't let your fingers go until the AC power cord is connected again and the

wording of "RGB" appears on the top left corner of your screen, and wait for 3 second. Under the

non-signal entry situation, if

When the Burn-in Mode is Unable to Eradicate...

1.) If the "RGB" is still on the top left corner of the screen, press

choose "Reset", and then Yes, and press

repeat the above steps.

2.) If the "RGB" is not found, disconnect the AC power cord first. Then press the

(don't let them go) until the AC power cord is connected, and wait for 2 to 3 seconds. When

"RGB" appears, repeat the above steps.

3.) Functions of OSD Keys

Auto Adjust

Up/Left Down/Right Power

Menu/Entry

ADP-1120/ADP-1150/ADP-1170/ADP-1190 User Manual

button and don't let them go) until the AC power cord is

Cable Not Connected

Power Indicator

is seen, exit is thus successfully made.

. When the screen goes black, disconnect power and

to enter "Miscellaneous" and

buttons