- ページ 7

アクセサリー Aplisens SGE-25S.SMARTのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Aplisens SGE-25S.SMART 20 ページ。 Smart level probes
Aplisens SGE-25S.SMART にも：ユーザーマニュアル (20 ページ)

ページを印刷する

INTRODUCTION

1.1. Purpose of the document

The subject of manual are smart level probes: SGE-25.Smart, SGE-25S.Smart, SGE-25C.Smart and

SGE-25S.Smart/Titan hereinafter referred to as probes in the manual. The manual applies to the fol-

lowing versions: standard and intrinsically safe Exi.

The manual contains data, guidelines and general recommendations for the safe installation and

operation of the probes, as well as procedures in the event of a possible failure.

It is forbidden to use devices in hazardous areas without appropriate permits.

Data on the hydrostatic level probes SGE-25.SMART, SGE-25S.SMART and

SGE-25C.SMART in intrinsically safe version according to ATEX are included in the

Explosion-proof Device Manual marked as EN.IX.SG.25.SMART.

1.2. Registered trademarks

HART

is registered trademark of FieldComm Group.

Windows

is registered trademark of Microsoft Corporation.

Google Play

is service registered and operated by Google

1.3. Set range

The following figure shows the set range of the probe and the limits associated with the allowable set

range, the digital conversion range and the saturation limits of the pressure measurement A/D

converter. By default, the LRV/URV points are assigned current values of 4 mA/20 mA. For a reversed

characteristic it is possible to reverse the assignment so that the LRV/URV points are assigned current

values of 20 mA/4 mA.

Figure 1. Set range and measurements limits.

Revision 01.A.001/2021.09

EN.IO.SGE.25.SMART

Inc.