- ページ 18
リフティングシステム APlusLift MT1500のPDF 設置マニュアルと操作説明書をオンラインで閲覧またはダウンロードできます。APlusLift MT1500 20 ページ。 Motorcycle lift
ページを印刷する
M a int e na nc e
6 .
6.2 Weekly Maintenance
•
Check air hoses and fittings for leaks and make sure connections are tightened.
•
Check all bolts, nuts, shafts, retaining clips, retainer rings, set screws and screws, ensure
they are aligned in proper place (grooves), secured, and tightened properly. Pivot shaft set
screws should always be checked to ensure that they are tight.
•
Check the cylinder rod. If it becomes dry, lightly oil it.
•
Lubricate the grease zerks located at either end of the pivot shaft.
•
Lubricate the grease zerks at the top end of the inside frame assembly.
6.3 Six Month Annual Maintenance
•
Lubricate the grease zerks located at either end of the pivot shaft.
•
Lubricate the grease zerks at the top end of the inside frame assembly.
•
Squirt some oil through the bleed hole in the plate end of the cylinder to lubricate the piston.
6.4
The follow ing repairs should only be performed by an
APlusLift authorized trained maintenance expert:
•
Replacement of shafts / axles.
•
Replacement of roll bearings.
•
Replacement or rebuilding pneumatic/air cylinders.
•
Check pneumatic cylinder rods and rod ends (threads) for deformation or damage.
•
Check cylinder mounting to make sure it's not loose and /or damaged.
Relocating or changing components may cause problems. Each component in the system must
be compatible; an undersized or restricted line will cause a drop in pressure. All foot pedal,
and hose connections should be sealed and/or capped until just before use. Air hoses can
be used to clean fittings and other components. However, the air supply must be filtered and
dry to prevent contamination. Most important - cleanliness - contamination is the most frequent
cause of malfunction or failure of pneumatic equipment, so always use an oil/air regulator.
Copyright
2020
C
www.apluslift.com
TM
Phone: 800-616-9618 Text: 425-300-2600 Email: [email protected]
APlusLift MT1500 & MT1500X
I N ST ALLAT I ON M a nua l
18 of 20