- ページ 7

電動工具 4CR 6.3800.1025のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。4CR 6.3800.1025 10 ページ。 Pneumatic palm random orbital sander

PNEUMATIC PALM RANDOM-

ORBITAL SANDER

6.3800.1005 / 6.3800.1025

GENERAL WARNINGS

The tool must be connected to a suitable dust extraction system.

SAFETY AND ACCIDENT PREVENTION INSTRUCTIONS

The safety and accident prevention instructions are reported in the "SAFETY INSTRUCTION" booklet which forms an

integral part of these documents; the operating instructions indicate the additional information required specifically for use of

the tool.

Never use the tools without the safety guards.

Any operations carried out on the tool must be effected with the tool disconnected.

Before starting the tool, ensure that it is held tightly and not in contact with the work surface.

The tool must be connected to a suitable dust extraction unit and applicable safety regulations must be observed if dusts

dangerous to health are likely to occur during sanding.

Due to risks that may arise during sanding, we recommend the constant use of P.S.D. (personal safety devices such as gloves,

headphones, goggles, face masks, etc.) according to laws in force to prevent or reduce accident probability.

Warning! Carry out the lubrication process outlined in the "Maintenance" paragraph. The appliance continues to work for a

few seconds after it has been switched off.

CORRECT USAGE

The sanders are designed for sanding wood, plastic, composite materials, paint/varnish, filling material and similar materials.

Metal and materials with an asbestos content must not be processed with these tools.

The tools may only be used for dry sanding.

Make sure the work piece is sufficiently fastened.

In the event of improper use, the user is fully liable for any damages or accidents.

STARTING UP

Before starting-up the tool, ensure that:

- the packaging is complete and does not show signs of having been damaged during storage or transport;

- the tool is complete; check that the number and type of components comply with that reported in this instruction booklet;

- the available compressed air production and distribution plant is capable of satisfying the requirements reported in Table I.

ASSEMBLING THE TOOL

Assemble the compressed air connection (not supplied) by screwing it into its seating (3).

COMPRESSED AIR CONNECTION (NOT SUPPLIED)

The tool is supplied without the compressed air connection; the user can use either a quick release coupling or hose type

connection according to his needs; the connection / coupling should have inner diameter of 8 mm. In the latter case the air line

must be fixed to the nozzle by a hose clip. In the latter case the hose must be fixed to the nozzle by a hose clip.

REMOVING AND MOUNTING THE BACKING PAD

- Use the spanner wrench (7) to unscrew the back-up pad bolt;

- Reverse the procedure when fitting the disc pad (6).

FITTING ABRASIVE PAPER DISCS

Press the abrasive disc into the pad ensuring that the holes in the abrasive paper coincide with extraction holes in the disc pad.