- ページ 31

サーバー Acer 930のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Acer 930 32 ページ。 High-performance system board
Acer 930 にも：バイオマニュアル (46 ページ), ユーザーマニュアル (16 ページ)

1.12.3

Correcting Error Conditions

As a general rule, if an error message says "Press F1 to continue," it is

caused by a configuration problem, which can be easily corrected. An

equipment malfunction is more likely to cause a fatal error, i.e., an error that

causes complete system failure.

Here are some corrective measures for error conditions:

Run Setup. You must know the correct configuration values for your

system before you enter Setup, which is why you should write them

down when the system is correctly configured. An incorrect

configuration is a major cause of power-on error messages, especially

for a new system.

Remove the system cover, following the directions in the housing

installation manual. Check that the jumpers on the system board and

any expansion boards are set correctly.

If you cannot access a new disk, it may be because your disk is not

properly formatted. Format the disk first using the FDISK and

FORMAT commands.

Check that all connectors and boards are secure.

If you go through these steps and still receive an error message, the cause

may be an equipment malfunction.

If you are sure that your configuration values are correct and your battery is

in good condition, the problem may lie in a damaged or defective chip.

In either case, contact an authorized service center for assistance.

System Board

1-31