- ページ 5
計測機器 Apogee SN-500のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Apogee SN-500 6 ページ。 Net radiometer
Apogee SN-500 にも： オーナーズマニュアル (19 ページ)
ページを印刷する
CUSTOMER SUPPORT
5. CUSTOMER SUPPORT
NORTH AMERICA
Customer support representatives are available for questions, problems, or feedback
Monday through Friday, 7:00 am to 5:00 pm Pacific time.
Email:
Phone:
+1.509.332.5600
Fax:
+1.509.332.5158
Website:
metergroup.com
EUROPE
Customer support representatives are available for questions, problems, or feedback
Monday through Friday, 8:00 to 17:00 Central European time.
Email:
Phone:
+49 89 12 66 52 0
Fax:
+49 89 12 66 52 20
Website:
metergroup.de
If contacting METER by email, please include the following information:
Name
Email address
Address
Instrument serial number
Phone
Description of the problem
NOTE: For products purchased through a distributor, please contact the distributor directly for assistance.
7
USING APOGEE NET RADIOMETERS WITH ZENTRA SYSTEM
2.1 SET UP MOUNTING ASSEMBLY
Apogee net radiometers must be level to accurately measure the four components of
net radiation. Each net radiometer purchased from METER comes with an AM-500 Net
Radiometer Mounting Bracket. The AM-500 can be mounted to either a horizontal or vertical
post depending on which set of U-bolt holes are used. However, mounting to a horizontal arm
that extends away from the main mounting mast is highly recommended.
1.
Align the cable M8 connector pins with the sensor M8 connector holes and seat
connectors fully.
2.
Tighten the cable screw until hand-tight.
M8 connectors are easy to overtighten. Do not use pliers or other tools to tighten
this connector.
3.
Attach the mounting bracket either to a horizontal arm (Figure 2) or vertical post using
the included U-bolts.
Mounting bracket
(model AM-500)
Figure 1 Apogee Net Radiometer sensor installed on mast or pipe
4.
If installation is in the Northern Hemisphere, ensure the sensor is oriented to the South
of the main mounting mast.
If installation is in the Southern Hemisphere, ensure the sensor is oriented to the North
of the main mounting mast.
5.
Thread the mounting rod into the body of the net radiometer.
6.
Clamp the mounting rod into the AM-500 mounting bracket using the integrated Philips
screws.
7.
Use the Philips screws on the mounting bracket to level the sensor according to the
bubble level on the top of the sensor.
4
Bubble level