- ページ 15

録音機器 Apogee Symphony I/O Mk II SoundGridのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Apogee Symphony I/O Mk II SoundGrid 20 ページ。 For units equipped with the wsg option card

Apogee Symphony I/O Mk II SoundGrid ユーザーマニュアル

When a Mic Pre Module is installed

The following additional controls become available:
4. Insert​ - Use this drop down to insert one of the eight rear panel send/return pairs into the input signal
path. Insert labels may be customized in the Setup screen. The insert point occurs after the mic pre and
high pass filter and before the A/D conversion stage.
5. 48v​ - Use this button to enable 48 volt phantom power on the corresponding Analog IN channel.
6. Polarity​ - Use this button to invert the polarity of the input signal.
7. High Pass​ - Use this button to engage an 80Hz high-pass filter on the input.
APOGEE SYMPHONY I/O MK II SOUNDGRID USER'S GUIDE
1. Analog Level Type Selector​ additional entries:
2. Gain Control​ - Use this knob to adjust the gain of the
3. Group​ - Channels set to the same group number will
Page 15
○ Choose ​ M ic​ when connecting microphones or direct
boxes, or any devices that needs to run through a
microphone preamplifier. -XLR Input only.
○ Choose ​ I nstrument​ when connecting a guitar or
keyboard, or any high impedance (Hi-Z) instrument to
the 1/4" input (balanced TRS or unbalanced TS). The
signal is sent through a Hi-Z to Low-Z conversion
circuit before sent through the microphone
preamplifier circuit.
mic pre.
have their Level Trim controls adjusted simultaneously.
Any level offset that exists before inputs are grouped will
be preserved after a group is chosen.