- ページ 2

コントローラー DaSeDa Electronics HM-75AのPDF マニュアルをオンラインで閲覧またはダウンロードできます。DaSeDa Electronics HM-75A 15 ページ。 Digital feeder controller

ページを印刷する

1. HM-75A / 710A controller front configuration

1. Data display window: Displays frequency, voltage, parameter, error code, etc. in numeric or text

2. RUN LED: It lights up during RUN, blinks during pause, and turns off at STOP.

3. Feed Back LED: It is ON when Feed Back ON and Sensor is connected.

Flickering when setting the vibration amount reference value, ON while the constant amplitude function is operating.

4. RUN Key: Pressing RUN key for a short time.

5. Volume: Used to change voltage / frequency / parameter value. Press repeatedly to select frequency / voltage repeatedly

6. STOP Key: Short press to stop the operation (STOP), press this button to initialize the controller when POWER ON. (See initializing the controller)

7. Selector: Frequency / Voltage / Parameter, etc. For setting menu selection, parameter value is displayed when button is pressed, and value can be changed by volume (1).

8. Power Key: Controller power switch.

9. Frequency LED: On when frequency is set.

10. Volt LED: On when voltage is set.

11. Slow Start LED: On when parameter Slow Up / Down time is set.

12. Sensor LED: On when parameter related to sensor is set. (Number of Sensors, On / Off Delay Time, NO / NC)

13. Ext Input LED: On when parameter related to external input is set. (On / Off Delay Time, NO / NC)

14. Feed Back LED: Turns on when setting parameters related to vibration such as constant amplitude control and constant amplitude time.

15. Ext Volume LED: Turn on when using external volume ON / OFF.