- ページ 3
舶用機器 Apollo REACH WIRELESS RW1300-210APOのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Apollo REACH WIRELESS RW1300-210APO 4 ページ。 Sounder vad base
ページを印刷する
PP5104/2022/Issue 1
Page 3 of 4
Maintenance and Service
Maintenance must be performed in accordance with all
applicable standards. Clean the detector externally using a
soft damp cloth. For full cleaning and recalibration detectors
should be returned to Apollo Fire Detectors.
Batteries
REACH Wireless devices are supplied with two CR123
batteries, battery A and B. The device switches periodically
between the two batteries on a controlled sequence. For
correct operation of the device, both batteries are required
with adequate capacity reserves.
When battery A reaches a low power threshold, it will trigger
a fault. This fault requires both batteries to be replaced in
every instance as both batteries should be discharging
equally.
When one (or both) batteries lack power, the Loop-Interface
receives a low battery message and will signal this event on
its in-built display, as well as relay the low battery message to
the fire control panel. The battery fault will also be signalled
by the device itself through its LED indicators if programmed
(see table 1).
Tamper detection
REACH Wireless devices contain an anti-tamper mechanism.
In the event of removal from its base, it sends a tamper
detection message to the Loop-Interface.
Tampering detection is not signalled visually by the device
LED.
EMC Directive 2014/30/EU
REACH Wireless Sounder VAD Base complies with the
essential requirements of the EMC Directive 2014/30/EU,
provided that it is used as described in this datasheet.
A copy of the Declaration of Conformity is available from
Apollo on request.
Construction Products Regulation (EU) 305/2011
The REACH Wireless Sounder VAD Base complies with
the essential requirements of the Construction Products
Regulation (EU) 305/2011
A copy of the Declaration of Performance is available from
Apollo on request.