ページを印刷する
Identifying Base Marking Codes
© Apollo Fire Detectors Limited 2004/JDR
Figure 4
Base wiring diagram
From
control
panel
2
3
Screen
(Functional
Earth)
Figure 6
From
control
panel
Feature
Description of Feature
2
3
Confirms that the detectors are wired in the correct
StartUp™
Screen
polarity
(Functional
Earth)
Maintenance procedure, takes just 4 seconds
FasTest®
to functionally test and confirm detectors are
functioning correctly
Shows that the drift compensation limit has been
DirtAlert™
reached
SensAlert®
Indicates that the sensor is not operating correctly
Normal
At the end of StartUp and FasTest (without flashing
Operation
LED as standard)
Flashing LED
Detector's red LED flashes in normal operation
Version
(at the end of FasTest)
Table 3
www.acornfiresecurity.com
The lettering here
indicates the type of base
© Apollo Fire Detectors Limited 2004/JDR
2
3
2
3
© Apollo Fire Detectors Limited 2004/JDR
Orbis features: LED status
2
3
2
3
www.acornfiresecurity.com
CONVENTIONAL DETECTORS
TimeSaverBase®
Terminal 4, Screen
(Functional Earth)
OUT +
From
control
IN +
panel
Direction of LED indicated by
mark on outside of moulding
2
3
Figure 5
Screen
(Functional
Earth)
3 bases wired with a common LED
From
control
panel
2
3
Screen
(Functional
Earth)
Figure 7
Red LED Status
Yellow LED Status
Flashes once per second
No Flash
Flashes once per second
No Flash
Flashes once per second in
No Flash
StartUp (Stops flashing when
StartUp finishes)
Flashes every 4 seconds (Flashes
No Flash
once per second in StartUp
No Flash
No Flash
Flashes every 4 seconds
No Flash
Snip along marked lines and
remove this part to lock the
detector to the base
LED —
IN & OUT —
© Apollo Fire Detectors Limited 2004/JDR
2
3
2
3
2
3
2
3
© Apollo Fire Detectors Limited 2004/JDR
13