- ページ 2

医療機器 Apollo Healthcare Technologies Limited Apollo 5 PlusのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Apollo Healthcare Technologies Limited Apollo 5 Plus 2 ページ。

ページを印刷する

SET-UP FOR AIR PUMP WITH

MATTRESS SYSTEM

Unpack the system and place the pump at the foot end

of the bed.

Remove the existing mattress from the bed frame (if

applicable).

Place the mattress on the frame, or on top of a foam

underlay mattress if using an overlay, and position

mattress so the air tube is at the foot of the bed.

Secure the mattress straps to the bed frame (or foam

mattress if using an overlay).

Hang the control unit on the foot board of the bed

frame.

Connect the mattress air hose to pump.

Check air hoses under the mattress to make sure they

are not kinked.

Plug in the control unit and turn it on.

The pump will now inflate the mattress.

10. Press the control button on pump to select alternation

or static therapy.

11. Set the required pressure by turning the comfort

control dial (from Soft to Firm).

12. Pressure is constantly monitored by the control unit.

When pressure is less than the selected pressure the

"Low Pressure" LED will illuminate and an alarm will

sound.

CPR FUNCTION

The mattress will feature a Cardio Pulmonary Resuscitation

(CPR) valve on one side.

In the event of cardiac arrest (depending on type of CPR

fitted) either, pull the CPR tag down firmly or twist the CPR

valve to the open position and unplug air hoses from pump.

These actions will start immediate deflation of the mattress

and CPR can usually be administered within 20 seconds.

Following deflation, re-inflation can only occur once the

CPR mechanism is returned to its closed position. In the

case of a pull tag CPR, open zipped mattress cover and

reinsert CPR tag mechanism to pipes. With a twist style

CPR, simply turn the valve to the ''CLOSE'' position.

Reconnect air hoses to pump and switch on.

Twist Style CPR

Pull Tag Style CPR

OPERATION

Adjustable

Alternate/Static

Comfort Setting

Control Switch

CLEANING

STORAGE & CARE

Control Unit (Air Pump)

SWITCH OFF THE ELECTRICAL SUPPLY TO THE

PUMP AND DISCONNECT THE POWER CORD

FROM THE MAIN SUPPLY BEFORE CLEANING AND

INSPECTION

Control unit (Air Pump) should be cleaned weekly

using a damp soft cloth and mild detergent. It's case is

manufactured from ABS plastic can be wiped down with

cleaning solution. (Do not use phenol based cleaning

solution)

Mattress

Mattress can be wiped down with cleaning solution.

Zipped cover can be easily removed for laundering

purposes. * Check mattress label for washing temperature

Storage and Care

Control unit (Air Pump):

•

Check the power cord and plug for abrasions or

excessive wear.

•

Plug in the unit and verify air flows from the units hose

connection ports

On/Off

•

Place in plastic bag for storage.

Switch

Function Status

Mattress Overlay:

LED Indication

•

Disconnect the air feed tubes. After the air is released

mattress can be folded. Place in plastic bag for storage.

For further technical support please visit http: