- ページ 17
ホットタブ Apollo Spas ChelanのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Apollo Spas Chelan 20 ページ。
ページを印刷する- 1. Table of Contents
- 2. Important Safety Instructions
- 3. Placement Information & Access
- 4. Spa Specifications
- 5. Electrical Specifications
- 6. Electrical Instructions
- 7. Start up Instructions
- 8. Draining the Water
- 9. Spa Care & Maintenance
- 9. Filtration System
- 9. Care of the Spa Cover
- 9. Vacation Care Instructions
- 9. Winterizing Your Spa
- 10. Water Maintenance
- 11. Troubleshooting
Using Chlorine System
Start-Up:
1. Let water reach 90°F.
2. Add 1 tablespoons (14 grams) of Apollo Spas Chlorinating Granules per 200 gallons of water.
3. Add 1 tablespoon (14 grams) of Spa Oxidizing Shock per 200 gallons of water.
4. Wait 24 hours and then test and balance Alkalinity and pH levels of the water using Alkalinity Increaser, pH
Up or pH Down respectively.
Note: Have jets on high speed for 1-2 minutes when adding chemicals to mix the chemicals through the water
more effectively. Circulate water using filtration mode for two additional hours.
After Each Use:
1. If you have an ozonator and/or use a Silver Sentinel Filter, add 1 teaspoon (4.75 grams) of Chlorinating
granules per person to the spa water (again, this is when you get out).
2. If you do not have an ozonator and/or use a Silver Sentinel Filter, add two teaspoons (9.5 grams) of Chlorine
Granules to the spa water.
3. If you do not use your spa for 3-4 days, add 1-2 tablespoons (4.75 - 9.5 grams) of Apollo Spas
Chlorinating Granules to the spa water for maintenance purposes.
Note: Have jets on high speed each time you add Chlorine to better mix it into the water.
Weekly:
1. Test water for Alkalinity and pH. Adjust as needed.
2. Add two (2) tablespoons (28 grams) of Spa Oxidizing Shock to spa water. Leave cover open and jets on high
speed for 20 minutes.
IMPORTANT: Shock significantly reduces pH and TA. One hour after adding Spa Oxidizing Shock test and
adjust pH and TA as needed.
Using Bromine System:
Start-Up:
1. Fill floating dispenser with pucks and open setting #7.
2. Add 2 tablespoons (28 grams) of Spa Oxidizing Shock per 265 gallons of water.
3. Add 2 1/2 tablespoons (35 grams) of Chlorinating Granules per 265 gallons of water,
to establish a Bromide reserve.
4. Test the Bromide level. Once bromine reads within the ideal range (3-5 ppm) turn tablet dispenser down
to 2 or 3 or more depending on bather load.
Weekly:
1. Fill floating dispenser with pucks and reset the setting if necessary.
2. Add 2 tablespoons (28 grams) of Spa Oxidizing Shock per 265 gallons of water.
3. Wait at least one hour and add 1 tablespoon (14 grams) of Best Defense per 265 gallons of water.
IMPORTANT: Spa Oxidizing Shock significantly reduces pH and TA. One hour after adding Spa Oxidizing
Shock test and adjust pH and TA as needed.
The use of Clarifiers and Foam inhibitors are not recommended with a disposable filter.
16