- ページ 2
ペイントスプレー Apollo Sprayers ECO TrueHVLP seriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Apollo Sprayers ECO TrueHVLP series 10 ページ。
ページを印刷するDO NOT USE EQUIPMENT BEFORE READING THIS SECTION
In order to assure safe operation of your spray system, please read the following instructions carefully.
Always follow solution manufacturer's safety instructions and warnings.
Always spray in a well-ventilated area.
We recommend that you use an approved face mask
Always store indoors, never allow unit to freeze.
Always use original manufacturers replacement parts
Never spray flammable materials from the Spray Tanning Center. .
Never alter or modify any part of this equipment; doing so can cause equipment
malfunction and/or bodily injury.
Never attempt to clean any part of the turbine motor while it is plugged in.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE TO
WATER.
Never leave spray equipment unattended. Keep away from children or any person not
familiar with spray equipment.
GROUNDING INSTRUCTIONS
This product should be grounded. In the event of an electrical short circuit, grounding reduces the risk
of electrical shock by providing an escape wire for the electric current. This product is equipped with a
cord that has a grounding wire and appropriate grounding plug. The plug must be plugged into an
outlet that is properly installed and grounded in accordance with all local codes and ordinances. Do
not operate unit with a damaged cord or plug. Do not pull or carry unit by the cord. Keep away from
heated surfaces. Do not unplug by pulling on the cord.
DANGER
Improper installation of the grounding plug can result in the risk of electric shock. Check with a
qualified electrician or service member if in doubt as to whether the product is properly grounded. Do
not modify the plug provided. If it will not fit the outlet, have the proper outlet installed by a qualified
electrician. Make sure that the spray-tanning center is connected to an outlet with the same
configuration as the plug. DO NOT USE ANY ADAPTERS WITH THIS PRODUCT.
Be sure that you are plugging the unit into a proper outlet for the electric current designed for your
spray system. Incorrect voltage will damage or burn out the motor.
USING EXTENSION CORDS
Use only a three-wire extension cord with a 3-slot receptacle similar to the plug on the turbine. Make
sure your extension cord is in good condition. When using an extension cord, be sure to select one
that will carry a heavy enough current for the turbine motor. An undersized cord will cause a drop in
the line voltage resulting in loss of power and overheating. If in doubt use the next heavier gauge.
The smaller the gauge number, the heavier the wire thickness. Please use the chart below as a guide
to selecting the proper size extension cord.
WARNING
For length less than: Use extension gauge:
25ft
(7.62m)
50ft
(15.24m)
100ft
(30.48m)
150ft
(45.72)
16AWG
14AWG
12AWG
10AWG
2