- ページ 10

ミュージックペダル APOLLO VIEW CANCANのPDF マニュアルをオンラインで閲覧またはダウンロードできます。APOLLO VIEW CANCAN 11 ページ。

Reading the Meters – In Peak mode, the 0dB indicator corresponds to a 10Vpp input signal

level. The +3dB indicator corresponds to approximately 14Vpp, a high level that could cause

clipping in subsequent stages. Aim for the 0dB LED to illuminate for optimal levels. Note that

the meter will show a lower level in Average mode since it doesn't respond to quick

transient peaks.

Meter Calibration – The meters are factory-calibrated. If recalibration is necessary, use the

trimmers on the back of the module. For the Left meter, use trimmer 1; for the Right, use

trimmer 2. With the meters set to Peak mode, input a 10Vpp 1kHz sine wave into the left

input and adjust the trimmer until the 0dB LED illuminates.

OUTPUTS

Out L & Out R - These outputs provide mono signals derived from the respective inputs.

They are AC-coupled and electromagnetically filtered, ideal for routing to other modules or

a dedicated output stage.

Can1 & Can2 Outputs - These stereo outputs are designed for connecting headphones,

providing high-quality sound for personal monitoring. They also offer the flexibility to drive

active monitors with a stereo-to-mono

Y-splitter

cable. To ensure safety and durability,

these outputs feature resettable fuses that protect against short circuits. This means if a

mono cable is mistakenly connected, the fuses will prevent any damage to the output stage,

preserving the longevity and reliability of your module.