- ページ 3

セキュリティシステム AddSecure Edge RT7020 EnterpriseのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AddSecure Edge RT7020 Enterprise 11 ページ。

1 DOCUMENT INFORMATION

1.1

Installation manual for Edge RT7020 Enterprise.

The PCB is to be mounted inside the cabinet on the plastic stands. The

cabinet is then mounted on the wall with four screws through the

designated holes on the back of the cabinet.

Please note that the side of the cabinet where the cables come through

shall be mounted upwards. The lid of the cabinet is then mounted with four

screws, one in each corner.

3 Edge RT7020 Enterprise – System description

Edge RT7020 is primarily used as an external dialer and/or IP-converter in

fire and intrusion system installations. It offers secure communication over

fixed line Ethernet (primary) or cellular via 2G, 3G or 4G networks

(secondary). Edge RT7020 can also be configured to allow remote access to

connected devices either via Ethernet or via cellular network (2G/3G/4G).

Edge RT7020 has got 8 digital inputs that can be used for connecting

external alarm devices, or for instance relay outputs from a fire alarm

panel.

Edge RT7020 is also equipped with a dialer capture input, which means it

simulates an analog telephone line. This input can receive alarms from an

intrusion or fire panel using the SIA protocol. It then converts and delivers

the alarm message via TCP/IP to an alarm receiving center. Alarm

transmission is triggered by:

1. Activation of any of the digital inputs

2. Activation of internal error controls (for instance Ethernet error, Cellular

3. Activation of alarm using the dial capture interface

4. Activation of alarm using the serial interfaces RS232 or RS485

error etc)