- ページ 4

セキュリティシステム Data Aire DAP IIIのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Data Aire DAP III 13 ページ。 Bacnet integration

Data Aire, Inc. DAP

2.2 Network Card Installation

IMPORTANT NOTE: The DAP III panel supports one network connection at a

2.2.1

For BACnet MS/TP interface, plug an RS-485 Multidrop communication network

card to the Communication Header J1 of the DAP III Display board. Make sure

the End jumper is on "T" (Terminate) position if the installed unit is the last unit in

the communication loop. In some case, the End jumper may not be required,

check with the BMS manufacturer for the requirement of this End jumper. See

Figure 3 below for the DAP III Display board with an RS-485 Multidrop card

installed.

After installing the network card, go to Menu 6-1 – Unit & Network ID in Group

Menu 6 – Network to set the unit network ID number. Go to Menu 6-2 –Network

Protocol to configure or verify the network protocol. Menu 6-2 to 6-7 are locked

menus, refer to the DAP III Operation Manual for the procedure of how to unlock

these menus before enter values. It is recommended to reset the DAP III panel

after changing the network protocol or the unit ID number.

Tx and Rx LED

Figure 3: DAP III Display Board With an RS-485 Multidrop Network Card

Engineering Document - 600-000-460

III BACnet Integration Instructions

time therefore only one type of the network card can be

installed.

RS-485 Multidrop Communication

RS-485 Communication Wiring

Shield

Page 4 of 13

Communication Header J1