- ページ 8

GPS Appareo STRATUS ESGのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Appareo STRATUS ESG 9 ページ。 Portable receiver connector plate
Appareo STRATUS ESG にも：パイロット・マニュアル (13 ページ), インストレーション・マニュアル (5 ページ)

ページを印刷する

position.

3. Remove the transponder, then install the rack.

I'm not getting good GPS reception. What should I check?

Check that there are 5 volts on the coax center conductor at the GPS



antenna.

If there are 5 volts: Try connecting another GPS antenna. Garmin



GA35, GA56, or another Antcom/RAMI antenna will work for testing.

You do not need to mount it for testing.

If there aren't 5 volts: Troubleshoot the coax, the transponder, and its



connections.

Perform the GPS oscillator reset procedure in the next FAQ.



How do I reset the GPS oscillator?

IMPORTANT: Make sure that the GPS antenna IS NOT connected during

reset.

1. Create a bench top harness using 22 AWG wiring for doing software

updates.

2. Connect the software update harness to the transponder.

1. Connect the power and ground to a power supply capable of 28 volts

and 1.5 amps.

2. Connect an RF load to the transponder antenna port. Leave all other

cables, ports, and pins unconnected.

3. Power on the transponder into test mode.

1. Power on the unit into configuration mode (while holding

the FUNC key, press and release the PWR key) with the software

update pin disconnected from ground.

2. Ground the software update pin within 10 seconds of powering on the

unit.

3. Confirm that you are in test mode by pressing the left arrow key. You

should see the LCD test screen.

4. Reset the GPS oscillator.

1. Navigate to the registration screen.

2. Enter "OSC" into the registration screen.

3. Press ENT to save the registration.