- ページ 3
ジャックス DURHAND C20-040V01のPDF 組み立て説明書をオンラインで閲覧またはダウンロードできます。DURHAND C20-040V01 6 ページ。 12" hydraulic vehicle positioning jack
ページを印刷するTOOL USE AND CARE
l
Read all the instructions and warnings first before attempting to operate this jack.
l
DO NOT operate jack on inclined surfaces. Jack must be used on a level surface only.
Unanticipated motion can occur as soon as jack lifts the tyre from surface.
l
DO NOT overload jack beyond the load rating (1500 lbs. per unit)
l
DO NOT start the vehicle's engine, or drive a vehicle while the jack is in use. Jacks are designed
for hand maneuvering of vehicles only.
l
DO NOT use jack to lift tyres wider than 12 inches.
l
DO NOT attempt to push jack over obstacles. Jack is designed to be used on level and smooth
surfaces only.
l
After lifting, be sure to always lock the pin in place before operating. Pull the pin out after
finishing work and then release the valve.
l
Do not force the tool. Tools do a better and safer job when used in the manner for which they
are designed. Plan your work, and use the correct tool for the job.
l
Store idle tools. When tools are not is use, store them in a dry, secure place out of the reach of
children. Inspect tools for good working condition prior to storage and before re-use.
l
Use only accessories that are recommended by the manufacturer for your model.
Accessories that may be suitable for one tool may create a risk of injury when used on another
tool.
l
Keep guards in place and in working order.
l
Never leave tool unattended.
OPERATION
1.
Place jack on floor and press down on the pedal to release pedal lock. Pull out the lock pin
from frame.
2.
Before operation, open the release valve by turning the hand-wheel counterclockwise. Expand
the jack with the hand-wheel to place the rollers around the tyre; position the jack so both
rollers are in contact with the tyre tread. To obtain the best control of the jack while
expanding the rollers around the tyre, place your left hand on top of the left side axle and
place your right hand at the center of the pedal. Close the release valve by turning the
hand-wheel clockwise to a snug-tight position; jack may now be used.
3.
Install jack so that the unit is parallel to the sidewall of the tyre to be lifted. Leave
approximately 3/4" of clearance between tyre and jack. This is very important. If unit is
misaligned, the tyre may hit the axle of the jack and not the rollers; this may damage the jack
and void the warranty.
4.
To lift tyre, flip the directional lever up, then place foot on pedal, depressing the pedal with
smooth, even strokes. Cycle pedal until tyre is lifted from surface one inch or less. After lifting,
the lower the tyre is to the ground the more stable jack will be. After lifting, be sure to
always lock the pin in place before operation. If using more than one jack, repeat