- ページ 5

リモートスターター Durite O-649-70のPDF 技術仕様をオンラインで閲覧またはダウンロードできます。Durite O-649-70 7 ページ。 12/24vdc jump starter pack

OPERATION GUIDE

Check the power status of the jump starter by pressing the power SWITCH (shown page be-

fore)

Assess the vehicle voltage by connecting the RED to +VE terminal and BLACK clamp to -VE

terminal. The unit should auto select the correct voltage.

When the starter can not recognize the correct voltage, you must manually press the corre-

sponding voltage button.

Attention: When using a 12V battery to power up a 24V vehicle, you must manually press the

24V button when the product is fully charged, then the product will continue charging to the

voltage required for starting 24V vehicle.

When charging via the 5V3A Socket:

1. Fully charge the jump pack, the voltage is 27V when the jump pack in full power.

2. Connect the RED clamp to the vehicle's battery positive(+) terminal and connect the BLACK

clamp to the vehicle's battery negative(-) terminal.

3. When the host display "XXX V"+ "Jump START READY" , start the car.

4. Start the vehicle.

5. When the vehicle is started, remove the jumper from the vehicle battery

When charging via the vehicle battery:

1. Connect the RED clamp to the vehicle's battery positive(+) terminal and connect the BLACK

clamp to the vehicle's battery negative (-) terminal.

2 .The jump pack automatically recognizes the corresponding 12V/24V model based on the

vehicle battery voltage. It will stop charging when charging to 13.5V/27V and displayes "Jump

START READY" .

3.Start the vehicle.

4 .When the vehicle is started, remove the jump pack from the vehicle battery.

Attention: please don't charge for product when the battery voltage <1 OV.

When you can't start the vehicle, please follow the steps as below and resolve it appropriate:

1 .Refer to the owner's manual to determine the battery voltage and ensure that the jump

packs output voltage is correct.

2. Turn off the vehicle ignition, switch and all accessories (lights, radio, etc.)

3. Ensure that the RED clamp is connected to the vehicle's battery positive(+) terminal

and connect the BLACK clamp to the vehicle's battery negative(-) terminal

4 .Press the voltage button that matches your vehicle for about 2 seconds.

5.The screen will display "XX.X V"+ "Jump START READY" according

to the selected voltage.

6 .The product will output for 30 seconds after automatic recognition / forced output (the

screen display "jump start ready"). Please start the car within 30 seconds

7. If the above operation still can not start the car, please confirm if the current product voltage

is consistent with the vehicle battery voltage. If the current product voltage is around 13V and

the vehicle battery voltage is 21V, it needs to press the 24V button, then try above operation

when the jump pack voltage reaches 27V.

8. If the above has been fulfilled then the vehicle will need to be inspected by a professional

who can assess the vehicle for the further fault.