- ページ 3

タッチターミナル AddSecure IRIS-4のPDF クイック・インストレーション&メンテナンス・マニュアルをオンラインで閲覧またはダウンロードできます。AddSecure IRIS-4 9 ページ。

IRIS-4
2 Series
Quick Installation and
Maintenance Guide

3. PaCkage ContentS

Contents dependent on model type:
• Dialler board in plastic housing
• Ethernet cable (IRIS-4 220 & 240)
• 2/3/4G antenna (IRIS-4 200 & 240)
• Stylus for touch screen navigation
• 18kΩ sense resistor for dial capture tamper detection
4. BoaRD
ConFIguRatIon
① = Touch screen
② = Serial (TTL)
③ = Front tamper
④ = Dial capture port
and screw terminals
⑤ = RS485
⑥ = Pin inputs
⑦ = SIM card holder
⑧ = 2/3/4G antenna
⑨ = Ethernet
⑩ = DC power
= Relays
⑫ = RS232
⑬ = Micro USB
⑭ = SYS LED
LeD CoLouR
InDICatIon
Yellow flashing
Not currently configured or indicating that there are some current faults outstanding .
Yellow constant
Communicating and no current faults (flickers on every poll) .
4
14
1
2
3
4
5
6
7
8
9
5. BeFoRe You StaRt
Monitoring Centre (aRC)
Make sure that the monitoring centre to which the IRIS-4 2 Series device will send alarm signals is equipped
with the appropriate IRIS Secure Apps receiving system . The following information should be obtained from
the Monitoring Centre .
Dialler account number:
Monitoring centre IP address:
ethernet Connection Details
The customer's Ethernet (LAN) network details are required in order to connect the IRIS-4 220 & 240 .
Obtain the following information from the customer .
Fixed IP address or DHCP:
If using DHCP then the following information will not be required
as it will be assigned by the network.
13
IP address:
12
Gateway address:
Subnet mask address:
11
10
2/3/4g SIM Card and access Point name
If the installation uses 2/3/4G then a SIM card will be required . The IRIS-4 240 will also need to be given a
2/3/4G 'Access Point Name' (APN) and other possible configurations as shown below . Obtain these from the
SIM card provider .
Access Point Name (APN):
User name (USR):
Password (PWD):
SIM Pin:
Fixed
DHCP
5