- ページ 18

安全装置 Data Signs PTL RemoteのPDF 操作およびメンテナンスマニュアルをオンラインで閲覧またはダウンロードできます。Data Signs PTL Remote 19 ページ。 Portable traffic lights

Troubleshooting Guide

This section contains some tips on handling some of the issues that may arise when using

the Traffic Lights. If you cannot resolve the issue you are experiencing using the information

below, please contact Data Signs on the Help Desk Via the Web site. As discussed above, the

Fault Log stored on the SD card in the Master Controller may assist in issue diagnosis.

Turning the Controller On

If the POWER light does not come on when the key-switch is turned to ON:

•

Check that the controller connector is inserted properly.

•

Check the fuse inside the Controller and on the battery fuse board.

•

Check that the battery voltage is above 10.5 Volts.

Radio Wireless Link failure

If the radio wireless link fails regularly, try changing the Channel set on all Controllers, as

some interference may be occurring on the operating channel. Power-cycle each unit after

the Channel has been set correctly

SD Card Failure

Never insert or remove the SD-Card with the power on, switch key

In the case of SD card failure, you will be notified on the display. Default values will be used if

the SD card fails. All parameters can be changed, however they will not be saved, so you will

need to enter your desired parameters each time the Master Controller is turned on, until the

SD card is replaced.

Lights Not Working

Check the connections on the controller or the lights.

If you need to ship the Controller or parts back to Data Signs for repair, contact the

Help-Desk at

datasigns.com.au/ServiceSupport/HelpDesk

Note: If shipping Controllers it is recommended to ship as a set, i.e. Master, Slave and

Remote. It will benefit to ship all these items as this will enable our service department to

perform a full operational test and diagnosis.

to OFF first.

D A T A S I G N S A U S T R A L I A P T Y L T D