- ページ 14

ミシンアクセサリー DURKOPP ADLER 0867 590134のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。DURKOPP ADLER 0867 590134 16 ページ。 Fitting remaining thread monitor for var. kits

ページを印刷する

Anbauanleitung des Restfadenwächters

Instructions for fitting remaining thread monitor

Electrical setting

4.1 Setting the thread monitor

6 8 7

Ausgabe/Edition:

10.2006

für div. Bausätze (siehe Pkt. 1.1)

for var. kits (see section 1.1)

The thread monitor is delivered with the basic setting.

In general there is no need to adjust the sensitivity of the

thread monitor !

The default setting of the sensitivity should only be altered, if the

thread monitor does not work properly.

(See setting the sensitivity).

Connections:

Connector 1 (X1) = Light barrier right hook,

Connector 2 (X2) = Light barrier left hook,

Connector 3 (X3) = Input and output of the sewing drive control.

Connector 4 (X4) = Additional output (+24V) for e.g. transducer

Connector 5 (X5) = Switched output, max. current 78mA.

Electrical setting of the thread monitor / light barrier

The sensitivity of the light barrier can be adjusted through the

potentiometer 7 (R4 for the right needle) and 6 (R10 for the left

needle). The sensitivity is factory set and should only be altered if

the thread monitor does not work properly.

Setting the sensitivity

From the "switching on" until the first seam beginning, the

remaining thread monitor is in the setting mode.

–

Setting the sensitivity with the potentiometer 7 (R4) for the

right hook, connector 1.

Turn clockwise = higher sensitivity,

Turn anti-clockwise = lower sensitivity

–

Setting the sensitivity with the potentiometer 6 (R10) for the

leftt hook, connector 2.

Turn clockwise = higher sensitivity,

Turn anti-clockwise = lower sensitivity

Sequence of the sensitivity setting

–

Put an empty bobbin in the corresponding hook and set the

hook in a way that the light barrier beam goes through the slit

of the bobbin case without obstacle and can be reflected back

by the surface of the bobbin.

–

Set the potentiometer to its highest sensitivity (turn it

clockwise) and turn the bobbin in the hook manually, until the

reflecting surface is found. The LED 8 (V10) flashes and the

output to the control as well as the additional output will be

switched on.

–

Now reduce the potentiometer sensitivity until the reflection of

the bobbin can just be recognized.

The setting mode will be automatically exited with the first seam

beginning.

Important:

In the setting mode, the LED 8 (V10) will flash one second with

every reflection.

Printed in Federal Republic of Germany

or lamps.

Teile-Nr./ Part-No.:

0791 867702

Blatt:

von

Sheet: 14

from 16