- ページ 8

ミシンアクセサリー DURKOPP ADLER 550-867のPDF 補足説明をオンラインで閲覧またはダウンロードできます。DURKOPP ADLER 550-867 20 ページ。 Btsr sensor

ページを印刷する
DURKOPP ADLER 550-867 補足説明
3
Checking the power
1. Open the control cabinet, the key for which is included with the machine.
2. Check whether LED (1) is lit up.
 If LED (1) is NOT lit up, there is no power.
3. If LED (1) is still lit up, turn off the power,  2 Work preparation, p. 4.
Abb. 5: Checking the power
6

Replacing the thread tension PCB

WARNING
Risk of injury from electricity
Double-check that the power is turned off.
Disconnect the machine from the power supply.
ATTENTION
Electrostatic charging may cause damage to equipment!
Work on the machine is ONLY permitted while wearing the antistatic
armband.
Handle the PCB only by its edges.
Do not push the PCB over a surface.
Replacing the thread tension PCB
①
(1) - LED
Additional Instructions 550-867 - 01.0 - 08/2017