- ページ 17

ミシンアクセサリー DURKOPP ADLER 806のPDF 取付説明書をオンラインで閲覧またはダウンロードできます。DURKOPP ADLER 806 19 ページ。

ページを印刷する

7.4.3 Carrying out the position balancing

Preparing the transfer plate

–

By means of the reflecting foil, having a diameter of about 5 mm,

cover the number 1 of the coding field.

–

Insert this transfer plate.

Read-in the position balancing for coding

–

Select the function "Position balancing".

–

Do not lower the transfer plate.

–

Displace the transfer plate by the arrow keys until the Symbol

"Coding OK" (Pos. 3) is no longer shown crossed.

The actual coordinates will be displayed.

If no position is found, check the following:

- The transfer plate must be in horizontal position.

The light barrier must be clean.

–

Press the RETURN.

Position balancing for the sewing position

–

The transfer carriage will move towards the upper sewing position.

–

Introduce 2 mm pin into needle bar.

–

Lower the transfer plate by the function "Lifting/lowering the

transfer plate ".

–

Lower the sewing head by the function "Lifting/lowereing the

sewing head ".

Use the arrow keys of the control unit for moving the 2 mm pin

across the upper bore hole of the transfer plate.

The actual coordinates will be displayed.

–

Turn the handwheel and check whether the 2 mm pin dips into the

bore hole in the transfer plate.

–

By means of the functions "Lifting/lowering the sewing head "

and "Lifting/lowering the transfer plate"Lift the sewing head and

the transfer plate and lower again.

Note:

By displacing the transfer plate in lowered state, the transfer plate

can be slightly displaced within its guides. Therefore, it is

necessary to check and, if required to correct the position once

again.

–

Press the RETURN key.

The sewing head will be lifted.

The transfer plate will be lifted.