- ページ 2

錠前 Duro Dyne DYNA-TITE CL23-WC6のPDF 組み立て方法と警告をオンラインで閲覧またはダウンロードできます。Duro Dyne DYNA-TITE CL23-WC6 2 ページ。 Cable lock

ページを印刷する

IMPORTANT: TO ENSURE THE INTEGRITY OF THE DURO DYNE CABLE LOCK SYSTEM,

USE THE CABLE LOCK ONLY WITH WIRE ROPE SUPPLIED BY DURO DYNE CORPORATION.

FOR STATIC LOAD APPLICATIONS ONLY!

ALWAYS CONFIRM ENGAGEMENT OF CABLE LOCK ON WIRE BEFORE

APPLYING THE LOAD:

By pushing the adjustment pin in the opposite direction

of the arrows on the cable lock and then pulling the cable also in the opposite

direction of the arrows on the cable lock.

PULL ADJUSTMENT PIN BACK AND PASS WIRE ROPE THROUGH DYNA-

TITE CABLE LOCK:

Failure to pull adjustment pin first may cause damage to

serrated teeth and reduce holding capacity.

TO ENSURE HANGING SYSTEM INTEGRITY AND SAFETY:

Dyne wire rope.

DO NOT USE FOR LOADS OUTSIDE THE STATED WORKING LOAD

LIMIT (WLL) OF THE PRODUCT.:

a minimum safety factor of 5:1. This WLL takes into account the specification

criteria of the Dyna-Tite Cable Lock and the wire rope.

DO NOT USE ON COATED WIRE ROPE:

to metal contact between the locking pawls in the Dyna-Tite and the wire rope.

As a matter of sound engineering practice, the Dyna-Tite assembly must be located no closer than 12 inches to the suspension point.

Model

CL23-WC6

*Hanging at angles will reduce the Working Load Limit. Please visit our website for a full list of warnings and

our effects of hanging at angles chart here: http://www.durodyne.com/DTTesting.php

THE PRODUCTS ARE PROVIDED ON AN "AS IS" BASIS; THERE SHALL BE NO EXPRESS OR IMPLIED WARRANTY, INCLUDING WITHOUT

LIMITATION, WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. SUPPLIER SHALL NOT UNDER ANY

CIRCUMSTANCES, BE LIABLE FOR INDIRECT, SPECIAL OR CONSEQUENTIAL DAMAGES OR LOST PROFITS.

DO NOT EXCEED THE STATED WORKING LOAD RANGE OF THE PRODUCT

Date Code:

81 Spence Street • Bay Shore, NY 11706 • Tel: 631-249-9000 • Fax: 631-249-8346

WARNINGS

Use only Duro

Each product is load rated and incorporates

It is important to maintain the metal

For Use With

WC6-CL23 Wire Rope

DO NOT APPLY PAINT OR OTHER COATING:

as these may impair the free movement of the locking pawls inside the Dyna-

Tite Cable Lock.

DO NOT APPLY LUBRICANT:

to any part of the assembly as this will alter the

surface nature of the wire rope and attract dirt and debris.

DO NOT USE FOR LIFTING:

(Under Hook slings) This product is designed

for static load applications only.

KEEP THE PRODUCT CLEAN AND FREE FROM DIRT:

removed from the product prior to assembly.

INSPECT PERIODICALLY:

Upon inspection, discard and replace if worn,

distorted, or damaged.

REMOVE DAMAGED WIRE ENDS:

cutters prior to inserting into the Dyna-Tite Cable Lock.

DO NOT USE IN CHLORINATED ATMOSPHERES

FOR DRY LOCATIONS ONLY

Safe Working Load at 5:1 Safety Factor*

50-640 lbs (25-291 kg)

to any part of the assembly

Any dirt should be

Using a designated pair of wire rope

(Luminaire Fitting)

14HE

7/5/17