- ページ 14

インパクトドライバ DUROFIX RI60165のPDF 情報マニュアルをオンラインで閲覧またはダウンロードできます。DUROFIX RI60165 16 ページ。 Brushless impact wrench

Apply forward pressure to the tool to prevent the socket from slipping off the bolt.

To start, turn impact wrench/driver on. Always check torque with a torque wrench.

The fastening torque can be affected by many factors including the following:

Voltage: Low voltage due to a nearly discharged battery will reduce the fastening

torque.

Socket Size: Failure to use the correct socket size will cause a reduction in fastening

torque.

Variable Speed Trigger Switch: Operating the tool at a reduced speed will reduce the

fastening torque.

Bolt Size: Larger bolt diameters generally require higher fastening torque. Fastening

torque will also vary according to length, grade, and torque coefficient.

Material: The type of material and surface finish of the material will affect fastening

torque.

Fastening Time: Longer fastening time results in increased fastening torque. Using a

longer fastening time than recommended could cause the screws to be overstressed,

stripped or damaged.

NOTE

Continuous use in variable speed range is not recommended. It may

damage the switch and should be avoided.

NOTE

When change the position of the control button, making sure the variable

speed switch is released.

NOTE

The first time the tool is run after changing the direction of rotation, you

may hear a click on start up. This is normal and does not indicate a problem.

WARNING

NOTE

This tool is lubricated before it leaves the factory. This lubrication

should last for the life of the tool. No further lubrication is required.

CLEANING

With the motor running, blow dirt and dust out of all air vents with dry air at least once

a week. Wear safety glasses when performing this. Exterior plastic parts may be

cleaned a damp cloth and mild detergent. Although these parts are highly solvent

resistant, NEVER use solvent.

MAINTENANCE

Remove the battery pack from this tool before cleaning solutions.

-14