- ページ 13

アンプ ABYSSOUND ASP-1000のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。ABYSSOUND ASP-1000 13 ページ。 Linear preamplifier

(„FLOATING" state).

•

All actions associated with connecting or disconnecting the

ASP-1000 signal cables must be carried out while the power

amplifier is turned off. It is also recommended to turn off the

preamplifier power supply.

FUNCTIONALITY – REMOTE CONTROL

The remote control is powered by two AAA batteries. Before use, remove the film

protecting the batteries from discharging.

The remote control provides the following control functions:

„POWER": turning the device on and off.

„1 - 4": choosing the RCA input.

„XLR": choosing the XLR input.

„DIRECT": choosing the external processor input.

„VOL" + / -: volume control. Pressing the +/- buttons causes a single interval

volume change, while holding it enables continuous regulation.

„INPUT" + / -: input change.

„-12dB" / „-6dB" / „0dB": damping level change.

„MUTE": muting the ASP-1000 output. In order to exit the MUTE mode, press the

desired damping level button.

„DIMM": button inactive.

All care activities should be carried out with the power plug

disconnected.

ASP-1000 preamplifier can be cleaned with lint free cloths (e.g. microfiber. Do not

use solvent-based solutions. Using very wet cloths is not allowed due to the risk of

water getting inside the device. Due to this fact it is recommended to use a dry or

slightly wet cloth. The silicone o-rings in the legs can be cleaned with a wetted

microfiber cloth. In order to preserve the surface of the casing in a perfect state it is

advised to change its position in cotton gloves (no fingerprints on the ASP-1000

casing).

P a g e