ページを印刷する
PG 8
STEP
7.
Turn the Hypastart to the off position
STEP
8.
Disconnect the lead clamps
PLEASE REFER TO YOUR ENGINE'S INSTRUCTION MANUAL
ON JUMP STARTING PRIOR TO USING HYPASTART.
NEVER CONNECT TO FUEL LINES
ALWAYS DOUBLE CHECK YOUR CONNECTIONS
CHARGING/ENERGIZING THE HYPASTART
USING THE CHARGE PORT
Located on the side panel of your Hypastart you will find a
3 pin canon socket. This socket can be used to energize/
charge your Hypastart from a 12V source only. Supplied with
your Hypastart is an AC charger with a canon plug adaptor.
THE AC WALL CHARGER MUST BE SWITCHED
ON BEFORE CONNECTING TO THE HYPASTART
It' s important you have the AC Wall Charger switched on
before connecting to your Hypastart.
With the Hypastart in the OFF position, simply plug the wall
charger into the AC outlet, plug the charger output lead into
the Hypastart by using the supplied 3 pin canon plug, switch
the charger on to charge the unit.
You can connect to a 12V vehicle supply for ALWAYS ON
STANDBY charge. Connecting directly to the vehicle 12V
system will keep the unit fully charged and ready to use.
Simply connect the vehicle power source to the 3-pin
socket, charging will start when the engine is started and
will automatically switch off the charging system shortly
after the engine has been switched off to prevent draining
the vehicle starter battery.
For more information on this feature please call Durst
Industries and speak with a technical representative.
PLEASE NOTE: WHEN USING THE CHARGE
SOCKET MAKE SURE THE HYPASTART IS IN THE
OFF POSITION OR DAMAGE MAY OCCUR TO THE
CHARGING SYSTEM.
OPERATING
INSTRUCTIONS
WARNING!
Eye protection (wear safety glasses) is recommended when
performing any procedures with the Hypastart.
WARNING!
Never attempt to jump start a battery with frozen
electrolyte. A frozen battery could explode from applying
a charge.
WARNING!
Super capacitors contain an electrolyte solution that may
irritate the skin if exposed. If bodily contact occurs, flush
with water for 15 minutes. If burning persists seek medical
attention.
WARNING!
DO NOT short circuit the starting leads.
OPERATING
INSTRUCTIONS
PG 9