- ページ 16
コントロールユニット Dataforth PWRM10-01のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Dataforth PWRM10-01 20 ページ。 Iot energy monitoring modules
ページを印刷する
MA1069 PWRM10-01 & PWRM20-01 Quick Start Guide
6.0 Acquiring Data from the Module
Selections on the left side of the panel give full access to module configuration and all features and
functions.
6.1 Enter Sensing Device Parameters with Sensor Configuration
Data will not be accurate until phase voltage and phase current sensors are configured.
First go to the Configuration | Sensor page, select devices used to measure phase currents and
phase voltages, and enter the device parameters.
Figure 15: Configuration | Sensor Page
Custom scaling parameters are available if required by an installation.
6.2 Data Display in Tables
Data is continuously collected from the module at the default poll rate of 1 second and posted to the
appropriate displays and charts.
The Data | Table page has a concise tabulation of the basic parameters measured.
Page 12 of 16
Figure 16: Data | Table Selection