- ページ 2

超音波ジュエリークリーナー Durston Tools 3.2LのPDF 使用方法をオンラインで閲覧またはダウンロードできます。Durston Tools 3.2L 2 ページ。 Pro ultrasonic cleaner

ページを印刷する

ULTRASONIC CLEANING

Ultrasonic cleaning is based on the cavitation effect cause by high frequency ultrasonic

wave vibration in the fluid. Microscopic bubbles are formed, and they implode violently

causing the cavitation which creates an intense scrubbing action on the surface of the item

being cleaned. The bubbles are small enough to penetrate microscopic crevices, cleaning

them thoroughly and consistently.

Ultrasonic cleaning is an extremely effective way of removing dirt and grime which would

normally require a longer cleaning period by hand. Small areas are easily cleaned with

Ultrasonic cleaning. It can be used to clean a wide variety of instruments and mechanical

parts, returning them to a bright clean condition without damage.

KNOWING YOUR MACHINE

The Durston Professional Ultrasonic Cleaner has an easy-to-use Control Panel, along with

an LED display for cleaning time and temperature. The heavy gauge stainless steel tank

has been created to ensure long time usage.

It also features a "degas function", with the ability to activate the cleaning liquid by

removing any air bubbles which will interfere with the Ultrasonic Cleaning action. The

high-performance transducers create an effective Ultrasonic wave action for enhanced

cleaning. The timer can be set between 1-60 minutes and the cleaning temperature

range is 0° - 80°.

Do not over-fill / over flow

Always unplug before

Only fill to the line

emptying the tank

Do not run continuously

Allow to cool between cycles

Included in the box

• Ultrasonic Cleaner

• Lid

• Mesh Basket

• Power Cable

USING YOUR ULTRASONIC CLEANER

1. Select your cleaning solution and fill to the line on the inside of the tank – do not exceed

the "max" line. Use only water or recommended cleaning concentrate to the instructed

proportions. Fill the tank with Fluid.

2. Plug in the power cord. Once the switch at the back of the unit is turned on the LED lights

will illuminate.

3. Turn the heater knob clockwise to set the temperature between 30° and 60°. After

reaching the set temperature, you can adjust between 30° and 60° as desired. The Blue light

will come on and the red cursor will blink throughout the heating cycle

4. Note: Optimal cleaning temperature is 40°-60° and the unit should not run at 80+ degrees

for long periods of time.

5. Activate the De-Gas function for removing the air bubbles in the cleaning solution. This

process will take approximately 5-10 minutes. Once no bubbles remain, you can turn this

feature off and continue.

6. Place your items into the wire basket and slowly submerge into the tank. The basket can

be hung on the edge of the tank which will keep the items fully covered by your cleaning

solution. The Timer can be set and the Ultra Sonic function can be turned on – the Ultra

Sonic mode will automatically turn off at the end of the time period.

7. Do not overload the Basket with items as this will affect the efficiency of the Cavitation.

8. When the cleaning process is complete the heater should be turned back to zero and the

unit turned off. Do not empty the unit until the power cable is removed. Please note while

using the Ultrasonic Cleaner, it will make a high-pitched noise and may create some spray.

Your Durston Pro Ultrasonic Cleaner has been made for professional cleaning

with high output transducers and components.

To ensure a long working life you must not run the machine for long periods

of time at high temperatures. Please follow all the guidelines in this booklet.

If you need any additional information or if any doubt on

how to use your machine, please contact [email protected]