- ページ 3

換気フード Addvent AVCH60のPDF インストール手順とユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Addvent AVCH60 4 ページ。 Cooker hood

ページを印刷する

Figure 1

Attention should be given to ensure that any applicable regulations

concerning discharge of exhaust air are fulfiled.

This appliance should be installed and maintained by a suitably qualified and

competent person in accordance with the relevant safety regulations.

Before connecting the appliance to the mains supply, ensure that the voltage

and frequency details on the rating plate are consistent with the source of

supply.

Installation

As stainless steel hoods scratch and mark

easily, carefully remove the protective plastic

ﬁlm from all exterior surfaces of the hood and

chimney only prior to ﬁnal installation.

At least two people will be required to mount

the hood.

Installing the hood

The cooker hood should be placed at a

height of 65cm above an electric hob or

75cm above a gas hob (see Figure 2).

Secure the hood mounting bracket to

the wall using the two ST5 x 50mm mounting screws and dry wall anchors.

Align the hood body with the hood mounting bracket. Gently lower the hood

until it securely engages the bracket. (see Figure 3, opposite).

Ensure the hood is level then fasten the hood body with the two screws at the

rear.

Figure 2

If using the hood in air extraction mode

fit the discharge collar (non-return flap)

into the air outlet adaptor (see Figure 4,

right).

For air extraction mode, attach an

adequate length of 150mm duct

(supplied) to the air outlet termination,

and connect the duct to the vent (on

wall or ceiling) (see Figure 5, right).

Connect the mains supply.

Fix the chimney mounting bracket to

the top Decorative Chimney piece with

chimney bracket screw.

Carefully place the decorative chimney

bottom into the recessed area of the

hood body top (see Figure 5, right)..

Carefully slide the decorative chimney

top up inside the decorative chimney

bottom. Secure the chimney mounting

bracket to the wall using the ST5 x

50mm mounting screws and dry wall

anchors and located on the wall.

Figure 5

Figure 3

Figure 4

Figure 6