- ページ 8

計測機器 Elseta IOMOD 4RTDのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Elseta IOMOD 4RTD 9 ページ。 Modbus

Fig. 6.10. Mass storage device warning

User then must delete existing file "firmware.bin", and simply upload new firmware file by drag and drop. (Fig 6.11.)

Fig. 6.11. Dragging and dropping new firmware file

Reconnect device and check firmware version. It should now represent the one it was updated to.

Testing With "THE VINCI" software

To test IOMOD 4RTD with default settings, user can connect device through RS485 to Modbus or IEC-60870 (depending

on firmware) master or using USB Simulation Mode. Example will show The Vinci Expert as serial interface converter

and adapter to PC with The Vinci software. Default settings – 9600 baud; 8 data, no parity, 1 stop bit. When opening

The Vinci software, choose Modbus serial – Master mode. In Settings tab, choose station number (default – 1);

configure tags (as described in section 2. Device operational information); press Start and go to Statistic tab:

Fig. 6.7. Example of results of Modbus testing