- ページ 17

バーコードリーダー Datalogic DS2100NのPDF クイック・リファレンス・マニュアルをオンラインで閲覧またはダウンロードできます。Datalogic DS2100N 20 ページ。 Compact laser scanner
Datalogic DS2100N にも：パンフレット＆スペック (2 ページ)

ページを印刷する

COMPLIANCE

LASER SAFETY

This product conforms to the applicable requirements of IEC 60825-1

and complies with 21 CFR 1040.10 except for deviations pursuant to

Laser Notice N° 50, date June 24, 2007. The scanner is classified as a

Class 2 laser product according to IEC 60825-1 regulations.

Disconnect the power supply when opening the device during

maintenance or installation to avoid exposure to hazardous laser light.

There is a safety device, which allows the laser to be switched on only

if the motor is rotating above the threshold for its correct scanning

speed.

The laser beam can be switched off through a software command (see

also the Genius Help On Line).

The laser diode used in this device is classified as a class 3B laser

product according to EN 60825-1 regulations and as a Class IIIb laser

product according to CDRH regulations.

Any violation of the optic parts in particular can cause radiation up to

the maximum level of the laser diode (35 mW at 630 to 680 nm).

AVOID EXPOSURE LASER LIGHT

IS EMITTED FROM THIS APERTURE

FCC COMPLIANCE

Modifications or changes to this equipment without the expressed written approval of Datalogic could void the

authority to use the equipment.

This device complies with PART 15 of the FCC Rules. Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and (2) this device must accept any interference received,

including interference which may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference

when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate

radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause

harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause

harmful interference in which case the user will be required to correct the interference at his own expense.

POWER SUPPLY

This product is intended to be installed by Qualified Personnel only.

This accessory device is intended to be supplied by a UL Listed or CSA Certified Power Unit with «Class 2» or

LPS power source, which supplies power directly to the scanner via the 25-pin connector.

CE COMPLIANCE

Warning: This is a Class A product. In a domestic environment this product may cause radio interference in

which case the user may be required to take adequate measures.

DS2100N QUICK GUIDE

Complies with 21 CFR 1040.10

except for deviations pursuant

to Laser Notice N°50,

date June 24, 2007

LASER LIGHT

DO NOT STARE INTO BEAM

CLASS 2 LASER PRODUCT

MAX. OUTPUT RADIATION 1 mW

EMITTED WAVE LENGTH 630~680 nm

TO IEC 60825-1:1993+A1:1997+A2:2001

CAUTION-CLASS 3B LASER LIGHT

WHEN OPEN AVOID EXPOSURE TO BEAM

Pat. US5992740, EP0789315B1

DATALOGIC AUTOMATION S.r.l.

Via S. Vitalino, 13 – 40012 Calderara di Reno

MADE IN ITALY-www.datalogic.com

Figure 12 - Warning and Device Class Labels