- ページ 2

バーコードリーダー Datalogic DX8200のPDF クイック・リファレンス・マニュアルをオンラインで閲覧またはダウンロードできます。Datalogic DX8200 16 ページ。

Electrical Safety

This product conforms to the applicable requirements contained in the European Standard for

electrical safety EN-60950-1 at the date of manufacture.

This symbol refers to operations that must be performed by qualified personnel only. Example:

opening the device.

This symbol refers to operations where there is danger of electrical shock. Before opening the

device make sure the power cable is disconnected to avoid electric shock.

This device must be installed to a power source equipped with on/off switch or breaker within range

of the operator as protection against grounding failures.

This device is protected against overloading by correct value fuses. For protection fuse

replacement make sure correct value fuses are installed. See "Replacing the Protection Fuses" in

the Reference Manual on the CD-ROM.

Laser Safety

The following information is provided to comply with the rules imposed by international authorities and refers to

the correct use of the DX8200 Controller scanner.

This scanner utilizes up to 3 low-power laser diodes. Although staring directly at the laser beam momentarily

causes no known biological damage, avoid staring at the beam as one would with any very strong light source,

such as the sun. Avoid that the laser beam hits the eye of an observer, even through reflective surfaces such as

mirrors, etc.

This product conforms to the applicable requirements of both EN 60825-1 and CDRH 21 CFR 1040 at the date of

manufacture. The scanner is classified as a Class 2 laser product according to EN 60825-1 regulations and as a

Class II laser product according to CDRH regulations.

There is a safety device which allows the laser to be switched on only if the motor is rotating above the threshold

for its correct scanning speed.

Use of controls or adjustments or performance of procedures other than those specified

herein may result in exposure to hazardous visible laser light.

WARNING

The laser light is visible to the human eye and is emitted from the windows on the lower side of the reader

(Figure B, 3).

Warning labels indicating exposure to laser light and the device classification are applied onto the body of the

scanner (Figure B, 4 and Figure A, 2):

For AC models

DX8200 CONTROLLER

QUICK GUIDE